Framerate Capped in Overwatch

Updated: 1 year ago
Article ID: 141374
Relevant Products:

Common Problems

My FPS is locked to 60 FPS no matter what I do.
I can't go over 30 Frames per second
My FPS is capped at a specific number

FPS caps are usually due to an game, driver, or power setting. Configuring these settings properly will allow you to increase your FPS. If your FPS is low, but not stuck at a specific number, use our low frame rate article. If your frame rate is not low, use our performance troubleshooting resources article.

In game menus are intentionally capped at 60 FPS. This cannot be increased. The troubleshooting below is only for frame rate issues while playing the game.

Note: Make sure your computer meets the Overwatch System Requirements before following the steps below. If your computer is on the low end of these requirements, try lowering your graphics settings.
  1. Changes to the software settings on your video card drivers may cause crashes or lockups. Reset your video driver settings to correct this problem.
  2. Incorrectly set or corrupted game settings may cause crashes, lockups, or performance issues. Reset your game settings to correct this problem.
  3. In game settings can prevent you from reaching higher frame rates. Change these settings to uncap your in game FPS.
    • Limit FPS
      1. Press Esc while in game and choose Options
      2. On the Video tab, find the Limit FPS option
      3. Set the drop down menu to Custom
      4. Move the Frame Rate Cap slider to your desired FPS
    • Vsync
      1. Press Esc while in game and choose Options
      2. On the Video tab, find the VSync option
      3. Toggle this setting to Off
  4. If you're playing on a laptop, optimize your power management settings and graphics options for gaming.
  5. Overheating can cause performance issues, game crashes, and full computer lockups. Check for overheating components.

Tried everything here?

If you have tried these steps and still require assistance, please visit our Technical Support Forums or contact us.